The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to. à aiguille interne. STANDARD. ISO. Second edition. Reference number. ISO (E). Provläsningsexemplar / Preview. STANDARD. ISO. Second edition. Reference number. ISO (E). This is a free 4 page sample. Access the full version online.
|Published (Last):||6 August 2005|
|PDF File Size:||15.44 Mb|
|ePub File Size:||5.3 Mb|
|Price:||Free* [*Free Regsitration Required]|
Copyright BIS has the copyright of all its publications. Fixed or removable fitting per- mitting venting of air while restricting 10555-5 preferably preventing the escape of blood. Users of Indian Standards should ascertain that they are in possession of the latest amendments or edition by referring to the latest issue of ‘BIS Catalogue’ and ‘Standards: Peripheral intravascular catheter designed for the introduction of withdrawal of liquids or devices into or from the peripheral vascular system.
BS EN ISO 10555-5:2013
Standards are also reviewed periodically; a 105555-5 alongwith amendments is reaffirmed when such review indicates that no changes are needed; if the review indicates that changes are needed, it is taken up for revision. When tested in accordance with annex E, fluid shall not leak out of the vent fitting within 15 s.
The assembly comprising at least a needle tube attached to and communicating with a needle hub. Review of Jso Standards Amendments are issued to standards as the need arises on the basis of comments.
Add the following reference: Figure 1 — Typical over-needle peripheral intravascular catheter NOTE 2 At the time of publication of this part of ISOthere is no acceptable, ieo test method to determine radio-detectability. I Principle Water is allowed to flow through the catheter and the amount of flow is measured either volumetrically or gravimetrically.
Limited collection of colours. Page 3, subclause 4. This does not preclude the free use, in the course of implementing the standard, of necessary details, such as symbols and sizes, type or grade designations. Round the calculated average water fiowrate to the nearest whole number of millilitres. Available from Munsell Color, N. Certain conventions are, however, not identical to those used in Indian Standards.
No part of the these publications may be reproduced in any form without the prior permission in writing of BIS. If a steel tube is used, it shall connply with ISO E-5 Test report The test report shall contain at least the following information: The number of significant places retained in the rounded off value should be the same as that of the specified value in this standard.
Measure the time taken for fluid to form the first falling drop at the back of the vent fitting. Designation and catalogue of CCR colours. Until that time, isp manufacturer may label his product “radio- opaque” provided he can support this claim by demonstrat- ing that he has an appropriate method for showing radio- opacity.
Pages 1 and 2 4. Ixo parts of this standard are as follows: Search the history of over billion web pages on the Internet. This Indian 01555-5 has been developed from Doc No.: Bureau of Indian Standards BIS is a statutory institution established under the Bureau of Indian Standards Act, to promote harmonious development of the activities of standardization, marking and quality certification of goods and attending to connected 110555-5 in the country.
Part 1 General requirements do The technical committee has reviewed the provisions of the following International Standard referred in this adopted standard and has decided that it is acceptable for use in conjunction with this standard: Assembly comprising at least a needle tube attached to, and communicating with, a needle hub.
105555-5 NOTE To improve the visibility of the solution, a colorant such as red izo blue food dye may be incorporated. International Standard ISO The fluid is allowed to flow into the needle, and the time taken for fluid to leak through the vent fitting is measured. An example of a suitable apparatus is shown in fig- ure B. Annex D shows examples of typical needle point geom- etries. All standards are subject to revision, and parties to agreements based on this part of ISO are encouraged to investigate isp possibility of applying the most recent editions of the standards indicated below.
I Principle A force is applied successively tensile and connpress- ive to the needle tube and needle hub and the tube- hub union is then examined for loosening.
EN ISO – European Standards
The details of conditions under which the licence for the use of the Standard Mark 105555-5 be granted to manufacturers or producers may be obtained from the Bureau of Indian Standards. The catheter tube may have a single lumen or multiple lumens.
At the time of publication, the editions indicated were valid.
Suggested colour references for opaque naaterials are given in annex C.