Manometers MP KIMO MP -K: from to °C -J: from to °C -T: from to °C CO/Temperature: CO: from 0 to ppm, from Consult KIMO’s MP brochure on DirectIndustry. Page: 1/4. This is the MP Thermo-Anemo-Manometer. It is an easy to use meter which can take complex measurements. The MP is designed to measure Air.
|Published (Last):||2 October 2012|
|PDF File Size:||9.1 Mb|
|ePub File Size:||18.10 Mb|
|Price:||Free* [*Free Regsitration Required]|
To modify the period, press Period with the access key. Use the arrows to modifiy the threshold value then press Validate to validate alarm threshold and back to measurement screen.
KIMO MP manometer buy in Kamenskoe
Click on Mesure to display values table of selected dataset. It is thus necessary to enter kimp real temperature of use to obtain more precise results.
With Pressure function, you can access to following sub-functions – Hold – see Air velocity – Config. If you click on average icon, max.
If the probe has been just connected, np screen indicates the remaining time of warm up then the measurement screen appears, indicates the concentration and places it on a bargraph.
When the measurement is fixed, press Min Max to access to maximum and minimum values of mpp measurement. Average – Rec Recording Veloci. Select Start with access key for launching measurement. On enabled mode, the probe is connected, the measurement is carried out and the value is displayed.
Press 1x in order to select HOLD function: Launch a planned dataset A planned dataset is composed of several locations.
KIMO MP 200 manometer
From this screen you can: Go to Recording menu. If Other is selected, you must enter a value. Preview of tables of points of datasets Dataset summary You can display tables of points kjmo datasets performed on the device. The operator can choose an automatic or a manual dataset, with an instant value or kiko average. For measurement launching, click on OK with the access key. Repeat this operation for the month, year, hour and minute. You must enter duration: Numbers of selected points and parameter for which calculation is carried out, are displayed For adding a new measuring point to this calculation, press OK to confirm.
Air velocity with Pitot tube: Click on OK to validate. Probe Hold Alarms Params Veloci.
Enter 020 time and interval of time between 2 measurements by selecting Period with access key. When the countdown is finished, the CO max is displayed. Create or launch a continuous dataset Select dataset A continuous dataset can be carried out using MP and is composed of several dated measuring points. Click on Esc to return to previous screen. Wire probes with Smart-plus system Wire probes with Smart-plus system are automatically recognized when connected to the instrument.
You can access this function selecting COmax with the access key CO max The CO is measured on an adjustable period, the maximum value measured in this period is called CO max. For each location, the operator can enter a theorical value and a tolerance for the parameter to be controlled.
The numbers of points is displayed. Press mpp in order to select Min-Max function: When the solenoid valve is enabled, it runs every minute.
It’s a community-based project which helps to repair anything. Summary screen of selected dataset is displayed. Alarm threshold corresponds to the right value on the bargraph. For others measurement modules, self-calibration is performed by disconnecting the two pressure inlets of the sensor, then by pressing Autoz key. Battery When battery indicator flashes it is recommended to change the batteries: If you want to see all values, select Visu.
To save your dataset click on Save with the access key. The number of points selected and the parameter are displayed.
Configuration sub-function allows to: You can view each measuring points if you click on Visu. On disabled mode, the probe is connected, the measurement is not carried out and the value is not displayed. Configuration If you use thermocouple probes, you must enter type into the Configuration sub-function.